RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
5. Remove the transmission range sensor (2) See: Sensors and Switches - A/T/Transmission Position Switch/Sensor/Service and Repair/48RE
(A-618) 4 Speed/Removal .
6. Position drain pan under transmission oil pan.
7. Remove transmission oil pan and gasket.
8. Remove fluid filter from valve body.
9. Remove bolts attaching valve body to transmission case.
10. Lower valve body enough to remove accumulator piston and springs.
11. Work manual lever shaft and electrical connector out of transmission case.
12. Lower valve body (1), rotate valve body away from case, pull park rod (3) out of sprag, and remove valve body.
Installation
INSTALLATION
1. Check condition of O-ring seals (1) on valve body harness connector (2). Replace seals on connector body if cut or worn.
2. Check condition of manual lever shaft seal (2) in transmission case. Replace seal if lip is cut or worn. Install new seal with 15/16 deep well socket
