RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
3. Remove joint from center bearing yoke.
4. Remove center bearing yoke (1) nut (2) and washer (3). Discard yoke nut.
5. Remove center bearing yoke (1) from shaft with two jaw puller.
6. Position Bearing Splitter Tool 1130 (1) between propeller shaft and center bearing (2).
7. Install Bridge 938 (3) on the splitter (1) and remove center bearing.
Installation
INSTALLATION
2500 AND 3500
