RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
1. Move the transmission manual shaft lever to the manual LOW position.
2. If necessary, install the TRS mounting bracket (2) into the transmission case. Using Adapter 8581 (3), tighten the mounting bracket to 34 Nm (300
in.lbs.).
3. Install the TRS (3) into the mounting bracket (2) with the wiring connector facing the front of the transmission.
4. Install the two screws to hold the TRS to the mounting bracket. Tighten the screws to 5 Nm (45 in.lbs.).
5. Verify proper sensor operation (1-4).
6. Move the transmission manual shaft lever to the PARK position.
7. Connect TRS wiring connector to the TRS and lower vehicle.
8. Refill the transmission fluid to the correct level.
