RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
Front Door Window Regulator: Service and Repair
Front Door Window Regulator - Installation
Power
INSTALLATION
1. Connect the door wire harness (6) to the window regulator (4) and install the regulator through the opening in the door (2).
2. Engage the two regulator bolts (7) to the door.
3. Install the bolt (5) that secure the window regulator to the door and tighten all three regulator bolts to 10 Nm (89 in. lbs.).
4. Position the regulator stabilizer (1) into the door and install the two nuts (3). Tighten the nuts to 10 Nm (89 in. lbs.).
5. Raise the window regulator (2) to the position shown.
6. Support the window glass and remove the wooden wedge or equivalent.
7. Position the window glass to the window regulator and install the two nuts (1) thought the two sight windows (3 and 4). Tighten the nuts to 10 Nm
(89 in. lbs.).
8. Disconnect the electric window switch from the door wire harness and reinstall the switch onto the door trim panel See: Power Window
Switch/Service and Repair/Installation .
9. Install the waterdam See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door
Waterdam/Installation .
10. Install the inner belt molding See: Window Glass/Front Door Window Glass/Front Door Window Glass Weatherstrip/Service and Repair/Front
Door Inner Belt Molding/Installation .
Manual
INSTALLATION
