RAM 2500 Truck 2WD L6-5.9L DSL Turbo (2008)
4. Remove the a-pillar trim panels (2) See: Body and Frame/Interior Moulding / Trim/Passenger Assist Handle/Service and Repair/A-Pillar
Trim/Grab Handle/Removal .
5. Remove the headliner (9) and from the inside of the vehicle, cut the upper urethane bonding from around windshield upper edge using a suitable
sharp cold knife (C-4849). A pneumatic cutting device can be used but is not recommended See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Headliner - Removal .
6. From the outside of the vehicle, cut urethane bonding from the remaining sides of the windshield using a suitable sharp cold knife (C-4849). A
pneumatic cutting device can be used but is not recommended.
7. Separate windshield from vehicle.
