RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
Power Seat Motor: Service and Repair
Power Seat Adjuster and Motors
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side seat, adjuster and motors assembly from the vehicle as a unit.
3. Unplug the power seat wire harness connectors at each of the three power seat motors.
4. Release the power seat wire harness retainers from the seat adjuster and motors assembly.
5. Remove the fasteners that secure the center seat cushion section to the brackets on the power seat adjuster.
6. Remove the screws that secure the power seat adjuster and motors assembly to the seat cushion frame.
7. Remove the power seat adjuster and motors assembly from the seat cushion frame.
8. Reverse the removal procedures to install.
