RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
Power Seat Motor: Service and Repair
Power Lumbar Adjuster and Motor
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the driver side seat back.
3. Unplug the wire harness connector at the power lumbar inflator motor.
Power Lumbar Adjuster And Motor Remove/Install
4. Unhook the power lumbar adjuster and motor assembly clips from the steel support rod welded to the seat back frame.
5. Remove the power lumbar adjuster and motor assembly from the seat back frame.
6. Reverse the removal procedures to install.