RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
EGR Tube
5. Remove EGR tube.
6. Remove the cab heater supply and return lines.
Engine Exhaust Manifold And Gaskets
7. Remove the engine exhaust manifold and gaskets.
8. Clean the sealing surfaces.
INSTALLATION
Engine Exhaust Manifold Bolt Tightening Sequence
1. Install the engine exhaust manifold and gaskets use anti-seize on capscrews. Tighten the exhaust manifold bolts in sequence to 43 Nm (32 ft. lbs.)
torque.
2. Install the turbocharger. Apply anti-seize to the studs and then tighten the turbocharger mounting nuts to 32 Nm (24 ft. lbs.) torque.
3. Position the charge air cooler (intercooler) inlet duct to the turbocharger. With the clamp in position, tighten the clamp nut to 8 Nm (72 in. lbs.)
torque.
4. Position the air intake pipe and the exhaust pipe onto the turbocharger. Tighten the clamps to 8 Nm (74 in. lbs.) torque.
5. Install the oil drain tube and oil supply line to the turbocharger. Tighten the drain tube bolts to 24 Nm (18 ft. lbs.) torque. Tighten the oil supply
