RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
Brake Light Switch: Adjustments
1. Push and hold brake pedal down
2. Pull switch plunger all the way out to fully extended position.
3. Push switch plunger inward 4 detent positions (or clicks). This is required preset position. Plunger will extend approximately 14 mm (0.55 inch)
out of housing at this setting.
4. Release brake pedal. Then lightly pull pedal fully rearward. Pedal will adjust switch plunger to correct position as pedal is moved to rear.
CAUTION: Do not use excessive force to move the pedal rearward for switch adjustment. Excessive force will damage the switch.
