RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
SPECIAL TOOLS/EQUIPMENT REQUIRED:
NOTE:
An updated J1962 cable has been released. This cable has a red colored connector at the DRBIII(R) connection. Use this cable whenever a flash is
being performed.
REPAIR PROCEDURE:
NOTE:
Whenever a controller is programmed, the software in the DRBIII(R) must be programmed with the latest revision level available.
NOTE:
If this flash process is interrupted/aborted, the flash process should be restarted and then follow the directions on the DRBIII(R).
1.
Before beginning the reprogramming procedure, remove any old flash reprogramming files from the DRBIII(R) memory. To clear the memory
from the MAIN MENU power up the DRBIII(R) and then:
a.
Simultaneously press the "MORE" and "YES" keys.
b.
A screen will appear requesting a "COLD BOOT".
c.
Follow the on screen instructions by selecting the "F4" key.
d.
When the DRBIII(R) reboots to the MAIN MENU, proceed to Step # 2.
2.
With the ignition switch in the "RUN" position, determine and record the "ECM part number" of the ECM currently in the vehicle. Using the
DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2005 Diagnostics"
c.
"All (Except Below)"
d.
"Engine"
e.
On 1998 1/2 - 2003 vehicles, select "Cummins". 2004 and later vehicles, proceed to next step.
f.
"Module Display"
g.
Record the "ECM part number" on the repair order for later reference.
