RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
Seat Belt Control Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the fasteners that secure the front seat adjusters to the floor panel.
Seatbelt Timer Control Module Remove/Install
3. Tilt the seat back and reach under the forward edge of the front seat center cushion to remove the two screws that secure the seatbelt timer control
module to the mounting bracket.
4. Lower the seatbelt control timer module from the mounting bracket far enough to access and unplug the wire harness connector.
5. Remove the seatbelt control timer module from under the front seat.
6. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).
7. Do not connect the battery negative cable at this time, See Seatbelt Control System Test Mode in the Diagnosis and Testing for the proper
procedures.
