dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Horn Switch|Service and Repair > < Diagram Information and Instructions|Page 876
Page 1
background image

Horn Switch: Testing and Inspection

WARNING:  ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY
.

For additional testing and inspection information please refer to Powertrain Management/Computers and Control Systems/ See: Body and Frame/Body
Control Systems/Central Timer Module

1. Disconnect and isolate the battery negative cable. Remove the steering column opening cover and knee blocker from the instrument panel.
2. Check for continuity between the metal steering column jacket and a good ground. There should be continuity.
3. Remove the driver side airbag module from the steering wheel. Refer to Air Bags and Seat Belts/Air Bags/Airbag Module Replacement for the

procedures. Unplug the horn switch wire harness connectors from the airbag module.

4. Unplug the horn relay from the Power Distribution Center (PDC). Check for continuity between the steering column half of the horn switch feed

wire harness connector and a good ground. There should be no continuity If OK, go to Step 5. If not OK, repair the short circuit as required.

5. Check for continuity between the steering column half of the horn switch feed wire harness connector and the horn relay control circuit cavity for

the horn relay in the PDC. There should be continuity. If OK, go to Step 6. If not OK, repair the open circuit as required.

6. Check for continuity between the horn switch feed wire and the horn switch ground wire on the airbag module. There should be no continuity. If

OK, go to Step 7. If not OK, replace the faulty horn switch.

7. Depress the center of the airbag module trim cover and check for continuity between the horn switch feed wire and the horn switch ground wire on

the airbag module. There should now be continuity. If not OK, replace the faulty horn switch.

Horn Switch|Service and Repair > < Diagram Information and Instructions|Page 876