RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 (1998)
Cables At Throttle Lever
3. Using finger pressure only, disconnect end of speed control servo cable from throttle lever pin by pulling forward on connector while holding lever
rearward.DO NOT try to pull connector off perpendicular to lever pin. Connector will be broken.
4. Using two small screwdrivers, pry throttle cable connector socket from throttle lever ball. Be very careful not to bend throttle lever arm.
5. Disconnect transmission control cable at lever arm (if equipped).
6. Squeeze pinch tabs on speed control cable and pull cable rearward to remove from cable mounting bracket.
7. Squeeze pinch tabs on throttle cable and pull cable rearward to remove from cable mounting bracket.
8. If equipped with an automatic transmission, refer to Transmission for transmission control cable removal procedures.
9. Disconnect wiring harness clip at bottom of bracket.
Electrical Connector At Bottom Of APPS
10. Remove 6 mounting bolts and partially remove APPS assembly from engine. After assembly is partially removed, disconnect electrical connector
from bottom of sensor by pushing on connector tab.
11. Remove APPS assembly from engine.
INSTALLATION
1. Snap electrical connector into bottom of sensor.
2. Position APPS assembly to engine and install 6 bolts. Tighten bolts to 12 Nm (105 in. lbs.) torque.
3. Connect wiring harness clip at bottom of bracket.
4. If equipped with an automatic transmission, refer to Transmission for transmission control cable installation procedures.
5. Install speed control cable into mounting bracket. Be sure pinch tabs have secured cable.
6. Install throttle cable into mounting bracket. Be sure pinch tabs have secured cable.
7. Connect throttle cable at lever (snaps on).
8. Connect speed control cable to lever by pushing cable connector rearward onto lever pin while holding lever forward.
9. Install cable cover.
10. Connect both negative battery cables to both batteries.
11. ECM Calibration: Turn key to ON position. Without starting engine, slowly press throttle pedal to floor and then slowly release. This step must be
