RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Fig.5 Power Seat Switch Remove/Install - Extended Cab
5. Remove the screws that secure the power seat switch.
INSTALLATION
1. Position the power seat switch on the seat cushion side shield and connect the electrical connector.
2. Install the screws that secure the power seat switch to seat cushion side shield.
3. Install the seat cushion side shield on the seat. Refer to Body for the procedure.
4. If equipped, install the recliner lever on the recliner mechanism release shaft.
5. If equipped, install the screw that secures the recliner lever to the recliner mechanism release shaft on the outboard side of the front seat.
6. Connect the battery negative cable.
