RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
10.
Remove 0-ring from the shaft seal sleeve and discard (Figure 5).
11.
Using a 1-3/8" drift or equivalent OD socket, press the seal out of the sleeve (Figure 6).
12.
Thoroughly clean all parts prior to assembly.
13.
Lubricate the OD of the new shaft seal with engine oil and press it into the sleeve with the seal face down, (Fig. 6) using a 1-3/8" drift or
equivalent size socket, making sure seal is fully seated in the housing.
