RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Fig.36 Cable/Lever/Throttle Linkage Cover
6. Remove cable cover (Fig. 36). Cable cover is attached with 2 Phillips screws, 2 plastic retention clips and 2 push tabs (Fig. 36). Remove 2 Phillips
screws and carefully pry out 2 retention clips. After clip removal, push rearward on front tab, and upward on lower tab for cover removal.
Fig.37 Throttle Cable At Throttle Lever
7. Using 2 screwdrivers, pry cable connector socket from throttle lever ball (Fig. 37). Be very careful not to bend throttle lever arm.
Fig.38 Cable Release
8. Squeeze 2 pinch tabs on sides of throttle cable at mounting bracket (Fig. 38) and push cable rearward out of bracket.
INSTALLATION
1. Install cable through mounting hole on cable mounting bracket (Fig. 37). Cable snaps into bracket. Be sure 2 pinch tabs are secure.
2. Using large pliers, connect cable end socket to throttle lever ball (snaps on).
3. Install remaining cable housing end into and through dash panel opening (snaps into position). The two plastic pinch tabs should lock cable to dash
panel.
