RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Headlamp Relay: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.16 Power Distribution Center
2. Unlatch and remove the cover from the Power Distribution Center (PDC).
3. See the fuse and relay layout label affixed to the underside of the PDC cover for headlamp (or security) relay identification and location.
4. Remove the headlamp relay by grasping it firmly and pulling it straight out from the receptacle in the PDC.
INSTALLATION
1. See the fuse and relay layout label affixed to the underside of the PDC cover for the proper headlamp (or security) relay location.
2. Position the headlamp relay in the proper receptacle in the PDC.
3. Align the headlamp relay terminals with the terminal cavities in the PDC receptacle.
4. Push firmly and evenly on the top of the headlamp relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
5. Reinstall and latch the cover onto the PDC.
6. Connect the battery negative cable.