RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
panel wire harness connectors. These connectors are retained on a bracket located on the inboard glove box opening reinforcement. Be certain that
both connectors are fully engaged and latched.
5. Position the passenger airbag ON/OFF switch and face plate unit to the opening in the instrument panel.
6. Install and tighten the three screws that secure the passenger airbag ON/OFF switch face plate to the instrument panel. Tighten the screws to 2.2
Nm (20 in. lbs.).
7. Reinstall the glove box onto the instrument panel. (Refer to INSTRUMENT PANEL/GLOVE BOX - INSTALLATION).
8. Reinstall the cluster bezel onto the instrument panel. (Refer to INSTRUMENT PANEL/CLUSTER BEZEL - INSTALLATION).
9. Do not reconnect the battery negative cable at this time. The airbag system verification test procedure should be performed following service of
any airbag system component. (Refer to RESTRAINTS - STANDARD PROCEDURE - VERIFICATION TEST)
