RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Power Seat Switch: Service and Repair
Driver Power Seat Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.3 Seat Switches And Bezel - Standard Cab
2. If equipped with a 6-way power seat, remove the two screws that secure the power seat switch and bezel unit to the seat cushion frame.
3. If equipped with a 8-way power seat, remove the seat cushion side shield from the seat. Refer to Body for the procedure.
Power Seat Switch Connector Remove
4. Pull the switch bezel or side shield unit out from the seat far enough to access the switch wire harness connector. Gently pry the locking tabs of the
switch away from the wire harness connector and carefully unplug the connector from the power seat switch module.