RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
Fig.6 Generator Connectors - Typical Denso
5. Remove B+ terminal mounting nut at rear of generator (Fig. 5) or (Fig. 6). Disconnect terminal from generator.
6. Disconnect field wire connector at rear of generator by pushing on connector tab.
7. Remove generator from vehicle.
INSTALLATION
1. Position generator to engine and snap field wire connector into rear of generator.
2. Install B+ terminal eyelet to generator stud. Tighten mounting nut to 12 Nm (108 in. lbs.) torque.
3. Install generator mounting fasteners and tighten as follows:
-
Generator mounting bolt-In these powered engines-54 Nm (40 ft. lbs.) torque.
-
Generator pivot bolt/nut-In these powered engines-54 Nm (40 ft. lbs.) torque.
CAUTION:
-
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
-
When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if
the belt is installed incorrectly, causing the engine to overheat.
4. Install generator drive belt.
5. Install negative battery cable(s) to battery(s).
