RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
7. Remove dust seal from the housing with a seal pick.
CAUTION: Use care not to score the housing bore when prying out seals and washer.
8. Remove retaining ring with snap ring pliers.
9. Remove washer from the housing.
10. Remove oil seal from the housing with a seal pick.
Fig. 7
11. Remove pitman shaft bearing from housing with a bearing driver and handle.
INSTALLATION
1. Install upper pitman shaft bearing, with Driver 8294 and Handle C-4171. Drive bearing into housing until the driver bottoms out.
NOTE: Install upper pitman shaft bearing with the part number/lepers facing the driver.