RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
6. If clutch cover will be reused, loosen cover bolts evenly, only few threads at a time, and in a diagonal pattern (Fig. 9). This relieves cover spring
tension evenly to avoid warping.
7. Remove cover bolts completely and remove cover, disc and alignment tool.
INSTALLATION
1. Check runout and free operation of new clutch disc.
2. Insert clutch alignment tool in clutch disc hub.
3. Verify that disc hub is positioned correctly. The raised side of hub is installed away from the flywheel.
4. Insert alignment tool in pilot bearing and position disc on flywheel surface (Fig. 10).
5. Position clutch cover over disc and onto flywheel (Fig. 10).
6. Align and hold clutch cover in position and install cover bolts finger tight.
7. Tighten cover bolts evenly and a few threads at a time. Cover bolts must be tightened evenly and to specified torque to avoid distorting cover.
8. Tighten clutch cover bolts to following:
^
5/16 in. diameter bolts to 23 Nm (17 ft. lbs.).
^
3/8 in. diameter bolts to 41 Nm (30 ft. lbs.).