RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2001)
11. Install release lever and bearing in clutch housing. Be sure spring clips that retain fork on pivot ball and release bearing on fork are properly
installed (Fig. 13). Also verify that the release lever is installed properly. When the release lever is installed correctly, the lever part number will
be toward the bottom of the transmission and right side up. There is also a stamped "I" in the lever which goes to the pivot ball side of the
transmission.
12. Install transmission. Refer to Manual Transmission/Transaxle, for proper procedures.
13. Check fluid level in clutch master cylinder.
