RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Antenna Cable: Service and Repair
Antenna Body and Cable
Antenna Body & Cable Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Antenna Coaxial Cable Connector
2. Reach under the passenger side of the instrument panel near the right cowl side inner panel to disengage the coaxial cable connector from the
retainer clip located on the bottom of the heater-A/C housing.
3. Remove the foam tape to access the coaxial cable connector. Disconnect the connector by pulling it apart while twisting the metal connector
halves. Do not pull on the cable.
4. Securely tie a suitable length of cord or twine to the antenna half of the coaxial cable connector. This cord will be used to pull or "fish" the cable
back into position during installation.
Antenna Mounting
5. Reach above the Powertrain Control Module (PCM) on the right side of the dash panel in the engine compartment to disengage the antenna
coaxial cable grommet from the hole in the dash panel.
6. Pull the antenna coaxial cable out of the passenger compartment and into the engine compartment through the hole in the dash panel.
