RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Lock Cylinder Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the door outside latch handle mounting hardware and linkage from the inside of the door.
Door Lock Cylinder Switch Remove/Install - Typical
3. From the outside of the door, pull the door outside latch handle out from the door far enough to access the door cylinder lock switch.
4. Disengage the door cylinder lock switch from the back of the lock cylinder.
5. Disconnect the door cylinder lock switch pigtail wire connector from the door wire harness connector.
6. Disengage the retainers that secure the door cylinder lock switch pigtail wire harness to the inner door panel.
7. Remove the door cylinder lock switch from the door.
INSTALLATION
1. Position the door cylinder lock switch into the door.
2. Engage the retainers that secure the door cylinder lock switch pigtail wire harness to the inner door panel.
3. Reconnect the door cylinder lock switch pigtail wire connector to the door wire harness connector.
4. Reinstall the door cylinder lock switch onto the back of the lock cylinder.
5. Reinstall the door outside latch handle mounting hardware and linkage on the inside of the door.
6. Reconnect the battery negative cable.
