RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Power Seat Switch: Service and Repair
Driver Power Seat
Driver Power Seat Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Standard cab models, remove the two screws that secure the power seat switch and bezel unit to the seat cushion frame.
3. Quad cab models, remove the seat cushion side shield from the seat. Refer to Body for the procedure.
Power Seat Switch Connector Remove
4. Pull the switch bezel or side shield unit out from the seat far enough to access the switch wire harness connector. Gently pry the locking tabs of the
switch away from the wire harness connector and carefully unplug the connector from the power seat switch module.
Power Seat Switch Remove/Install - Typical
5. Remove the screws that secure the power seat switch.
INSTALLATION
1. Position the power seat switch on the seat cushion side shield and connect the electrical connector.
2. Install the screws that secure the power seat switch to seat cushion side shield.
3. Install the seat cushion side shield on the seat. Refer to Body for the procedure.
4. If equipped, install the recliner lever on the recliner mechanism release shaft.
5. If equipped, install the screw that secures the recliner lever to the recliner mechanism release shaft on the outboard side of the front seat
6. Connect the battery negative cable.
