RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Air Dam: Service and Repair
FRONT AIR DAM
REMOVAL
Fig. 1
1. Using a trim stick C-4755 or equivalent, remove the fog lamp trim bezels. (Fig. 1)
2. Remove the air dam screws through the fog lamp opening (1 per side).
3. Remove the two outboard screws.
4. Remove the three middle screws and remove the air dam.
INSTALLATION
1. Position the air dam onto the bumper and seat the carrot type fasteners fully.
2. Starting at the center screw install the three middle screws.
3. Install the screws through the fog lamp opening.
4. Install the two outboard screws.
5. Position the fog lamp trim bezels into the bumper and seat fully.