RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Parking Brake Cable: Service and Repair
Rear Parking Brake Cable
Removal
REMOVAL - REAR PARK BRAKE CABLE
1. Raise and support the vehicle.
2. Lockout the parking brake cable.
3. Loosen cable adjuster nut.
4. Remove the rear park brake cable from the intermediate park brake cable.
5. Compress tabs on cable end fitting on the rear park brake cable to the frame mount bracket. Then pull the cable through the bracket.
6. Disengage the park brake cable from behind the rotor assembly.
7. Compress cable tabs on each cable end fitting at the brake cable support plate.
8. Remove the cables from the brake cable support plates.
Installation
INSTALLATION - REAR PARK BRAKE CABLE
1. Push each cable end through the brake cable support plate hole until the cable end fitting tabs lock into place.
NOTE: Pull on the cable to ensure it is locked into place.
2. Push the cable through the frame bracket.
3. Lock the left cable end fitting tabs into the frame bracket hole.
4. Install the rear cables into the tensioner rod behind the rear of the brake assembly.
