RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Cruise Control Servo Cable: Service and Repair
REMOVAL
With Automatic Transmission
1. Disconnect both negative battery cables at both batteries.
2. Remove cable/lever/linkage cover. Refer to Speed Control Servo Removal/Installation.
3. Remove (disconnect) servo cable from servo. Refer to Speed Control Servo Removal/Installation.
Fig. 3 Servo Cable At Throttle Lever
4. Using finger pressure only, disconnect end of servo cable from throttle lever pin by pulling forward on connector while holding lever rearward.
DO NOT try to pull connector OFF perpendicular to lever pin. Connector will be broken.
5. Squeeze 2 pinch tabs on sides of speed control cable at mounting bracket and push cable rearward out of bracket.
6. Remove cable from vehicle.
INSTALLATION
With Automatic Transmission
1. Install (connect) end of speed control servo cable to speed control servo. Refer to Speed Control Servo Removal/Installation.
2. Install cable through mounting hole on mounting bracket. Cable snaps into bracket.
3. Connect servo cable to throttle lever by pushing cable connector rearward onto lever pin while holding lever forward.
4. Connect negative battery cables to both batteries.
5. Before starting engine operate accelerator pedal to check for any binding
6. Install cable/lever cover
