RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
2. Measure the bearing journals and lobes (Fig. 92).
CAUTION: If Camshaft lobes are worn, requiring camshaft replacement, it is necessary to replace the tappets also.
Camshaft Bushing/Bores
Camshaft bores No. 2-7 do not use a bushing.
1. Inspect the camshaft bushing and bores for signs of excessive wear.
2. Measure the camshaft bushing and bores (Fig. 93) with a telescoping bore gauge and micrometer. If out of specification, Refer to CAMSHAFT
BEARING, SERVICE AND REPAIR.
3. Inspect camshaft bushing oil hole for alignment with cylinder block (Fig. 94).
