RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Horn Relay: Description and Operation
HORN RELAY
The horn relay is located in the Power Distribution Center (PDC) in the engine compartment near the battery.
The horn relay is normally activated by the horn switch to control the sounding of the vehicle horn or horns.
However, it can also be activated by an output of the Central Timer Module (CTM) to provide an audible indication that unauthorized vehicle use or
tampering has been detected.
The horn relay is a electromechanical device that switches battery current to the horn when the horn switch grounds the relay coil.
If a problem is encountered with a continuously sounding horn, it can usually be quickly resolved by removing the horn relay from the PDC until further
diagnosis is completed. See the fuse and relay layout label affixed to the inside surface of the PDC cover for horn relay identification and location.
The horn relay is a International Standards Organization (ISO) micro-relay. Relays conforming to the ISO specifications have common physical
dimensions, current capacities, terminal patterns, and terminal functions. The ISO micro-relay terminal functions are the same as a conventional ISO
relay. However, the ISO micro-relay terminal pattern (or footprint) is different, the current capacity is lower, and the physical dimensions are smaller
than those of the conventional ISO relay
The ISO relay consists of an electromagnetic coil, a resistor or diode, and three (two fixed and one movable) electrical contacts. The movable (common
feed) relay contact is held against one of the fixed contacts (normally closed) by spring pressure. When the electromagnetic coil is energized, it draws the
movable contact away from the normally closed fixed contact, and holds it against the other (normally open) fixed contact.
When the electromagnetic coil is de-energized, spring pressure returns the movable contact to the normally closed position. The resistor or diode is
connected in parallel with the electromagnetic coil in the relay, and helps to dissipate voltage spikes that are produced when the coil is de-energized.
