RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
NOTE:
If the ECM is not operational, the "ECM part number" can be obtained from the label on the controller. For 1998 1/2 - 2002 vehicles, if the
label on the controller is not legible, proceed to next step. For 2003 and later vehicles, if the label on the controller is not legible, record the
"Reference No." for use later. The "Reference No." is located in the Reference No. box at the top, center of the Engine Data Plate (Fig. 1). Do
not use the reference number shown in the figure. The Engine Data Plate is located on the intake side of the breather cover or affixed to the
APPS bracket.
3.
Page back to the "Main Menu"
4.
Determine if the vehicle is equipped with SKIM. Using the DRBIII(R) select:
a.
"DRBIII Standalone"
b.
"1998 - 2005 Diagnostics"
c.
"All"
d.
"System Monitor"
e.
"J1850 Module Scan"
f.
Look for "SKIM" in the list of modules.
5.
If the vehicle is not equipped with SKIM then proceed to Step # 6. If the vehicle is equipped with SKIM obtain the vehicle Personal Identification
Number (PIN) before continuing with Step # 6. This information is available from:
a.
The original selling invoice.
b.
The DealerCONNECT system under the "Sales" or "Parts" tabs - select "Key Codes".
c.
By contacting the District Manager.
CAUTION:
Failure to install the SKIM pin number into the module after flashing the Cummins ECM will cause a start and stall condition.
6.
Open the hood, install a battery charger and verify that the charging rate provides approximately 13.5 volts.
7.
If the old "ECM part number" is known, or for 2003 and later vehicles, proceed to Step # 14. On 1998 1/2 - 2002 vehicles, if the old "ECM part
number" is not known, proceed to next step.
