RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
b.
"1998 - 2005 Diagnostics"
c.
"All"
d.
"TheftAlarm"
e.
"SKIM"
f.
"Miscellaneous"
g.
"Cummins ECM Replaced"
h.
Follow the directions on the DRBIII(R) screen. When the process is complete, proceed to Step # 27.
26.
On vehicles not equipped with SKIM, manually enter the VIN in the ECM. Using the DRBIII(R) select:
a.
"DRBIII Standalone"
b.
"1998 - 2005 Diagnostics"
c.
"All"
d.
"Engine"
e.
"Cummins Controller (ECM/ENGINE)"
f.
"Miscellaneous"
g.
"CM84X Check VIN"
h.
Follow the directions on the DRBIII(R) screen. When the process is complete, proceed to next step.
NOTE:
Due to the Cummins controller programming procedure, a DTC may be set in other modules (PCM, TCM, BCM, MIC, SKIM, etc.) within the
vehicle, if so equipped. Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase
these DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's
erased.
NOTE:
The following step is required by law.
27.
Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 2).
POLICY:
Reimbursable within the provisions of the warranty.
