RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Oil Pressure Sensor: Service and Repair
REMOVAL
1. Disconnect the battery negative cables.
2. Disconnect the oil pressure sensor connector (Fig. 154).
3. Using a suitable socket, remove the oil pressure sensor from the block (counter-clockwise).
INSTALLATION
1. If the sensor is not being replaced, inspect the O-ring (Fig. 155) and replace if necessary.
2. Install the oil pressure sensor and tighten to 16 Nm (144 inch lbs.) torque.
3. Connect the battery negative cables.
4. Start engine and check for oil leaks at the sensor.
