RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Ignition Switch Lock Cylinder: Service and Repair
LOCK CYLINDER
REMOVAL
The ignition key must be in the key cylinder for cylinder removal.
1. Disconnect negative cable from battery.
2. If equipped with tilt column, remove tilt lever by turning it counterclockwise.
3. Remove upper and lower covers (shrouds) from steering column.
4. If equipped with automatic transmission, place shifter in PARK position.
5. A retaining pin is located at side of key cylinder assembly.
a. Rotate key to RUN position.