RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
panel wire harness connectors. These connectors are retained on a bracket located on the inboard glove box opening reinforcement. Be certain that
both connectors are fully engaged and latched.
5. Position the passenger airbag ON/OFF switch and face plate unit to the opening in the instrument panel.
6. Install and tighten the three screws that secure the passenger airbag ON/OFF switch face plate to the instrument panel. Tighten the screws to 2.2
Nm (20 in. lbs.).
7. Reinstall the glove box onto the instrument panel.
8. Reinstall the cluster bezel onto the instrument panel.
9. Do not reconnect the battery negative cable at this time. The airbag system verification test procedure should be performed following service of
any airbag system component. (Refer toRESTRAINTS - STANDARD PROCEDURE - VERIFICATION TEST)