RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Fuse: Service and Repair
GENERATOR CARTRIDGE FUSE
If a generator cartridge fuse fails, be certain to inspect and test the vehicle charging system before replacing the cartridge fuse and returning the
vehicle to service. Refer to Charging System in the index for the charging system diagnostic procedures.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Unlatch and remove the cover from the Power Distribution Center (PDC).
3. Remove the two screws that secure the generator cartridge fuse to the two B(+) terminal stud bus bars within the PDC.
4. Remove the generator cartridge fuse from the PDC.
INSTALLATION
1. Position the generator cartridge fuse onto the two B(+) terminal stud bus bars within the PDC.
2. Install and tighten the two screws that secure the generator cartridge fuse to the two B(+) terminal stud bus bars within the PDC. Tighten the
screws to 3.4 Nm (30 in. lbs.). Be certain that both screws are tightened to the proper torque value.
3. Install and latch the cover onto the PDC.
4. Reconnect the battery negative cable.
