RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
17.
Clean and lightly lubricate the white plastic bushing located under the gear shift blocker bracket assembly with Lubriplate® white grease (Figure
3).
18.
With the white plastic bushing in place on the gear shift lever housing, install the new gear shift blocker assembly (Figure 3).
19.
Clean and lightly lubricate the black plastic washer, wave washer and steel washer with Lubriplate white grease (Figure 3).
20.
Install the wave washer, black plastic washer and flat steel washer in the order shown in Figure 3 while aligning the square holes in the steel
washer with the alignment tabs on the gear shift housing.
21.
Install gear shift lever pivot screw and tighten to 105 in. lbs. (12 N.m) (Figure 3).
22.
Pull on the gear shift lever to compress the gear shift lever spring and remove the pencil.
23.
Clip the overdrive gear shift switch wiring harness into the plastic clip located on the gear shift blocker bracket.
24.
Place the gear shift module assembly into position on the steering column.
