RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
5. Install the yoke with Installer D-l91 and Yoke Holder 6719A (Fig. 23).
6. Install the pinion yoke washer and nut.
7. Hold pinion yoke with Yoke Holder 6719A and tighten shaft nut to 597 Nm (440 ft. lbs.) (Fig. 24). Rotate pinion shaft several revolutions to
ensure the bearing rollers are seated.
8. Rotate pinion shaft using an inch pound torque wrench. Rotating resistance torque should be equal to the reading recorded, plus a small amount for
the drag the new seal will have (Fig. 25).
NOTE: The bearing rotating torque should be constant during a complete revolution of the pinion. If the rotating torque varies, this indicates a binding
condition.
9. Install propeller shaft with the installation reference marks aligned.