RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
3. Place Inclinometer 7663 on yoke bearing (A) parallel to the shaft (Fig. 4). Center bubble in sight glass and record measurement.This measurement
will give you the transmission or Output Yoke Angle (A).
4. Rotate propeller shaft 90 degrees and place Inclinometer on yoke bearing parallel to the shaft (Fig. 5). Center bubble in sight glass and record
measurement. This measurement can also be taken at the rear end of the shaft. This measurement will give you the Propeller Shaft Angle (C).
5. Subtract smaller figure from larger (C minus A) to obtain Transmission Output Operating Angle.