RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
9. Grasp protruding bearing cap with vise jaws and tap link yoke with a mallet and drift to remove bearing cap (Fig. 19).
10. Flip assembly and repeat Step 6, Step 7, Step 8 and Step 9 to remove the opposite bearing cap.
11. Remove the cross centering kit assembly and spring (Fig. 20).
12. Press the remaining bearing caps out the other end of the link yoke as described above to complete the disassembly.
ASSEMBLY
CAUTION: All alignment marks on the link yoke and propeller shaft yoke must be aligned during assembled.
1. Apply Extreme Pressure (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores.
