RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
Fig. 16
7. Remove the two lower and loosen the two upper bolts. (Fig. 16)
8. Slide the regulator up and out of the keyhole slot.
9. Remove the regulator from the door panel opening.
INSTALLATION
1. Install the regulator through the hole in the inner door panel.
2. Position the regulator and slide the upper bolts into the keyhole slots.
3. Install the lower two bolts.
4. Tighten the regulator bolts to 10 N.m (89 in.lbs).
5. Position the stabilizer, install the nuts and tighten to 10 N.m (89 in.lbs).
6. Using the window handle raise the regulator to the position shown in (Fig. 14).
7. Remove the glass support and connect to the regulator lift plate.
8. Install the glass nuts and tighten to 10 N.m (89 in.lbs).
9. Remove the window handle and install the waterdam.
