RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN C (2002)
8. Disconnect the electrical connector. (Fig. 12)
9. Remove the lower regulator bolt and loosen the upper two. (Fig. 12)
10. Slide the regulator up and out of the keyhole slots in the door panel.
11. Remove the regulator through the hole in the inner door panel.
INSTALLATION
1. Install the regulator through the hole in the inner door panel.
2. Position the regulator bolts into the keyhole slots and slide into place.
3. Install the lower regulator bolt and tighten all three to 10 N.m (89 in.lbs).
4. Connect the electrical connector.
5. Position the stabilizer, install the nut and tighten to 10 N.m (89 in.lbs).
6. Raise the regulator to the position shown in (Fig. 11).
7. Remove the glass support and connect to the regulator lift plate.
8. Install the glass nuts and tighten to 10 N.m (89 in.lbs).
9. Disconnect the window switch and install into the door trim panel.
10. Install the waterdam.
