RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Some vehicles are equipped with the hood ajar switch integrated into the hood latch assembly. This type of hood ajar switch is not
serviced separately and the hood latch assembly must be replaced.See: Body and Frame/Doors, Hood and Trunk/Hood/Hood
Latch/Service and Repair/Hood Latch - Removal
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. Remove the push pin retainers and upper radiator seal.
4. From the top of the mounting bracket (3) on the upper radiator cross member (1) , squeeze the two hood ajar switch latch tabs (5) together and pull
the switch (4) upward.
5. Pull the hood ajar switch up through the hole in the mounting bracket far enough to access and disconnect the jumper wire harness connector from
the switch connector receptacle.
6. Remove the hood ajar switch from the mounting bracket.
