RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Trunk / Liftgate Lock Cylinder: Service and Repair
Lock Cylinder - Installation
INSTALLATION
1. Install the lock cylinder (2) and install the screws (1).
2. Install the latch release handle (3). See: Tailgate/Tailgate Release Handle/Service and Repair/Latch Release Handle - Installation
Lock Cylinder Coding Instructions
1. If present, remove the protective label off of the new lock cylinder.
2. Insert the key that is intended for everyday use, fully into the cylinder.
3. Slowly rotate the key clockwise, while maintaining full key insertion, to 180 degrees or slightly more (6 or 7 o'clock position).
NOTE: The lock will code at 180 degrees.
4. Then rotate the key counter-clockwise to 90 degrees or 3 o'clock.
5. You will hear the lock activate, then rotate the key to vertical key-out position and remove the key.
