RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Disconnect and isolate the negative battery cable.
2. Remove the affected seat See: Service and Repair.
3. Remove the affected seat cushion cover, cushion and pan.
4. Disconnect the electrical connector from the front tilt motor (1).
5. Remove the screws retaining the front tilt motor to the seat adjuster.
6. Remove the front tilt motor from the seat adjuster.
REAR TILT MOTOR
1. Disconnect and isolate the negative battery cable.
2. Remove the affected seat See: Service and Repair.
3. Remove the affected seat cushion cover, cushion and pan.
4. Disconnect the electrical connector from the rear tilt motor (3).
5. Remove the screws retaining the rear tilt motor to the seat adjuster.
6. Remove the screw and washer from the motor shaft.
7. Remove the rear tilt motor from the seat adjuster.