RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Cushion: Service and Repair
Vented Seat Pad - Removal
REMOVAL
NOTE: Seat back shown. Seat bottom similar.
1. Disconnect and isolate the negative battery cable.
2. Remove the seat cushion or seat back cover.
3. Disconnect the heated seat electrical connector.
4. Carefully guide the vented seat pad flange (3) through the opening (2) in the seat foam (1).
5. Remove the vented seat pad (3) by peeling the pad away from the cushion (1). Be careful not to remove excessive foam from the cushion.
