RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Installation
Rear
REAR
1. Install the 2nd row heated seat switch assembly into the floor console rear trim panel. Push the switch firmly into the trim panel until the retaining
tabs are fully seated.
2. If equipped, connect the 2nd row heated seat switches (1), 115 Volt power outlet (3) and the auxiliary audio jacks (2) electrical connectors to the
floor console rear trim panel.
3. Align the trim panel (3) to the console and insert the bottom tabs into the mounting slots.
4. Tilt the upper edge of the trim panel (1) forward and apply hand pressure to seat all retaining clips.
5. Connect the battery negative cable.
6. Verify 2nd row heated seat system operation.
Front
FRONT
