RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Cowl Moulding / Trim: Service and Repair
Cowl Panel Cover - Installation
INSTALLATION
1. Position the panel assembly cowl cover (1) over the pivot shafts.
2. Push down on the cowl cover while moving it forward to make sure the six hooks are forward of the windshield edge.
3. Center cowl cover over the wiper pivot shafts, push down on the cowl cover then push rearward with both hands and slide hooks under the edge of
the windshield.
4. Secure the front edge to the cowl by installing the push pins (2).
5. Fit soft rubber ends to fender by pulling up molded in feature to engage to fender flange.
6. Install the wiper arms See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arm - Installation.
