RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Brake Bleeding: Service and Repair
Antilock Brake System Bleeding
ABS BRAKE BLEEDING
ABS system bleeding requires conventional bleeding methods plus use of a scan tool. The procedure involves performing a base brake bleeding,
followed by use of the scan tool to cycle and bleed the HCU pump and solenoids. A second base brake bleeding procedure is then required to remove
any air remaining in the system.
1. Perform base brake bleeding See: .
2. Connect scan tool to the Data Link Connector.
3. Select ANTILOCK BRAKES, followed by MISCELLANEOUS, then ABS BRAKES. Follow the instructions displayed. When scan tool displays
TEST COMPLETE, disconnect scan tool and proceed.
4. Perform base brake bleeding a second time See: .
5. Top off master cylinder fluid level and verify proper brake operation before moving vehicle.
